Having “hard water” means that your water supply contains high levels of minerals like calcium and magnesium.
While hard water is generally harmless to drink, it can damage your boiler and clog your pipes, which are expensive to repair or replace (a new boiler can cost as much as $10,000!).
To prevent these problems, it’s important to identify and remove hard water by installing a water softener. Use these steps to test for hard water.
What You’ll Need
- clear plastic bottle with a cap
- liquid dish soap
Fill your plastic bottle with about 10 ounces of water from your kitchen sink. Add about a teaspoon of liquid dish soap, close the plastic bottle and give it a good shake.
If the soap foams up naturally, you probably don’t have hard water and can end your test at this point.
If it doesn’t foam, but instead forms a milky film at the top of the bottle, hard water could be an issue and you need to continue the test.
If you have public water, contact your local water utility and ask them for a recent hard water reading.
If you have a private well, you’ll need to test your water yourself.
Contact your local department of health and ask them which labs in your area can test your water. You can usually send a sample of your water to them and have it tested for free.
It’s generally best to avoid home tests, which can be inaccurate and unreliable.
Check your results.
Hard water is generally measured in grains per gallon (GPG) of dissolved minerals.
If your water has more than 4 GPG, your hard water levels are considered high.
If you GPG is 4 or higher, it’s a good idea to install a water softener to reduce your levels.
A water softener can cost anywhere from $100-$3,000 depending on the model, method of softening and water volume requirements of your house.
It’s also a good idea to have your water softener professionally installed, which can cost $100-$600.